สินค้าแนะนำ

The InnovairFlex™ Series are the only duct smoke detectors flexible enough to fit configurations from square to rectangular and everything in between.

The 5151 thermal detector meets the needs for applications where rapid response is vital and rapid temperature increases would only be caused by a fire emergency.

The NOTIFIER NBG-12 Series is a cost-effective, featurepacked series of non-coded manual fire alarm pull stations.

Maintenance personnel can open station for inspection and address setting without causing an alarm condition.

System Sensor’s 800 series detectors are 2-wire conventional profile plug-in detectors aimed to meet the performance criteria designated by UL.

The control panels provide reliable fire signaling protection for small to medium-sized commercial, industrial, institutional buildings.

NOTIFIER’s SFP-2402 Fire Alarm Control Panels bring the latest in microprocessor technology to conventional fire controls.

The System Sensor BEAM1224 is transmitter / receiver unit and a reflector as fourwire conventional projected beam smoke detectors.

Manual Fire Alarm Pull Stations provide a single-action, normally open contact, alarm initi- ating point for use with Fire Alarm Control Panels.

The SD-651 is designed to meet the performance criteria designated by UL. Its sensing chambers are sealed against back pressure air flow, dirt, and insects.

The Thermotech 302 Series rate-anticipation heat detectors operate within a controlled range of two to three degrees of their set points, regardless of the speed or rate of temperature rise.

System Sensor® SpectrAlert® Advance selectable-output horns, strobes and horn/strobes are rich with features guaranteed to cut installation times and maximize profits.

System Sensor® SP2 and SP3 Series speakers combine performance, functionality, and flexibility in the latest line of dualvoltage evacuation speakers.

System Sensor® SpectrAlert® Advance selectable-output horns, strobes and horn/strobes are rich with features guaranteed to cut installation times and maximize profits.

System Sensor selectable output horns, strobes, and horn strobes are rich with features guaranteed to reduce installation times and maximize profits.

FCM-1 Addressable Control Module provides Notifier intelligent control panels a circuit for Notification Appliances (horns, strobes, speakers) or to monitor a telephone circuit.

FRM-1 Addressable Relay Module provides the system with a dry-contact output for activating a variety of auxiliary devices, such as fans, dampers, control equipment, etc.

FMM-1 is a standard-sized module (typically mounts to a 4" [10.16 cm] square box) that supervises either a Class A (Style D) or Class B (Style B) circuit of dry-contact input devices.

FMM-101 is a miniature monitor module (a mere 1.3" (3.302 cm) H x 2.75" (6.985 cm) W x 0.5" (1.270 cm) D) used to supervise a Class B (Style B) circuit of dry-contact input devices.

FZM-1 is a standard-sized module used to monitor and supervise compatible two-wire, 24 volt, smoke detectors on a Class A (Style D) or Class B (Style B) circuit.

FDM-1 is a standard-sized dual monitor module used to monitor and supervise two independent two-wire Style B (Class B) dry-contact initiating device circuits (IDCs) at two separate, consecutive addresses in intelligent, two-wire systems.

The FRM-1 Relay Control Module is intended for use in intelligent, two-wire systems where the individual address of each module is selected using the built-in rotary switches.

The NOTIFIER ISO-X Fault Isolator Module is used with the NFS-3030, AM2020, AFP1010, NFS-640, AFP-400, AFP-300, AFP-200, AFP-100 and System 5000 (equipped with an AIM-200 module) to protect the system against wire-to-wire short circuits on the SLC loops.